- Abstract viewed - 349 times
- PDF downloaded - 1552 times
Affiliations
Indania Febry Sulistiyani
Jurusan Kimia FMIPA Universitas Negeri Semarang
Agung Tri Prasetya
Jurusan Kimia FMIPA Universitas Negeri Semarang
How to Cite
Most read articles by the same author(s)
- Suryat Hadi Kusuma, Agung Tri Prasetya, Mohammad Alauhdin, PENENTUAN KADMIUM DALAM LIMBAH ELEKTROPLATING DENGAN METODE KOPRESIPITASI MENGGUNAKAN AMONIUM PIROLIDIN DITIOKARBAMAT , Indonesian Journal of Chemical Science: Vol 4 No 1 (2015)
- Mujiatul Makiyah, Wisnu Sunarto, Agung Tri Prasetya, ANALISIS KADAR NPK PUPUK CAIR LIMBAH TAHU DENGAN PENAMBAHAN TANAMAN THITONIA DIVERSIVOLIA , Indonesian Journal of Chemical Science: Vol 4 No 1 (2015)
- Ainin Khilya, Agung Tri Prasetya, OPTIMASI APLIKASI ARANG AKTIF ALANG–ALANG DALAM MENURUNKAN KADAR Cd2+ PADA LARUTAN , Indonesian Journal of Chemical Science: Vol 5 No 1 (2016)
- Vinny Rochmah, Agung Tri Prasetya, Triastuti Sulistyaningsih, Adsospsi Ion Logam Pb2+ menggunakan Limbah Serbuk Gergaji kayu Mahoni , Indonesian Journal of Chemical Science: Vol 6 No 2 (2017)
- Sri Haryani, Agung Tri Prasetya, Diah Ika Rusmawati, PEDAGOGICAL CONTENT KNOWLEDGE (PCK) CALON GURU DAN GURU KIMIA PADA MATERI BUFFER , Unnes Science Education Journal: Vol 5 No 3 (2016): December 2016
- Slamet Budi Setyo, Triastuti Sulistyaningsih, Agung Tri Prasetya, Ella Kusumastuti, Iron Extraction from Coal Fly Ash Using HCl Solution , Indonesian Journal of Chemical Science: Vol 10 No 2 (2021)
Iron Extraction from Coal Fly Ash Using HCl Solution
Abstract
About 780 million tonnes of fly ash are produced annually worldwide. The use of fly ash is still minimal, causing fly ash piles to increase. Based on this, a study was conducted on the extraction of iron from coal fly ash using HCl as a solvent. This study aims to determine the Fe content in fly ash extracted using HCl with variations in HCl concentration and extraction time. This research begins with the preparation of fly ash samples using an oven. Fly ash that has been prepared and extracted using HCl added with MIBK and EDTA was then characterized using XRF, FTIR and AAS. The results showed that the highest Fe content (11.48%) was obtained from the extraction using 9N HCl for 1 minute. The greater the concentration of HCl and the faster the extraction time, the more Fe extracted.