Laboratory Testing Performance of Hot Mix Asphalt Containing Waste Materials

Hery Awan Susanto(1), Hery Awan Susanto(2), Bagyo Mulyono(3),


(1) Universitas Jenderal Soedirman
(2) Universitas Jenderal Soedirman
(3) Universitas Jenderal Soedirman

Abstract

Abstract. Road conditions are frequently subjected to damage that outlasts the road's design life. One of these is due to the material's mechanical capability, which is insufficient to withstand traffic loads and weather conditions. The incorporation of plastic and tire waste into Hot Mix Asphalt is one of the efforts to improve the material's mechanical quality (HMA). In addition to reducing the asphalt concentration in the mixture, the percentage of plastic and tire debris reduces the environmental impact. The use of plastic and tire waste in HMA can aid in the creation of green roads. The goal of this research is to see how plastic and tire waste affect HMA performance in Marshall testing. The research was conducted by making test samples with variations of waste materials percentage. Then, the Marshall test was carried out. Analysis of test results includes volumetric properties and Marshall characteristics. The test results showed that the addition of plastic and tire waste was able to improve the performance of the HMA mixture. However, the performance of the HMA mixture will decrease due to the influence of water soaking the HMA mixture. The addition of the optimum waste was obtained by 2.5% at the optimum asphalt content of 5.5%.

Keywords

Hot Mix Asphalt, Marshall, Plastic, Tire, Waste

Full Text:

PDF

References

Silvia, S. Perkerasan Lentur Jalan Raya. (1999). Bandung: Nova.

Saliko, D., and Erlingsson, S. Damage Investigation of Thin Flexible Pavements to Longer Heavier Vehicle Loading Through Instrumented Road Sections and Numerical Calculations. Road Materials and Pavement Design Journal, Volume 22, pages: S575-S591. (2021).

Asphalt Overlays for Highway and Street Rehabilitation, MS-17. (1983). Asphalt Institute.

Hardiyatmo,H.C. Pemeliharaan Jalan Raya. Gadjah Mada University Press. (2007). Yogyakarta.

Shahin, M. Y. Pavement Management For Airport, Road, and Parking Lots. (1994). Chapman & Hall, New York.

Ahmad, J., Yusoff, N.I.M., Hainin, M.R., Rahman, M.Y.A., and Hossain, M. Investigation into Hot-Mix Asphalt Moisture-Induced Damage under Tropical Climate Conditions. Construction and Building Materials, 50(2014): 567-576. (2014).

Yang, S.H., Susanto, H.A., and Fath, A.A. Comparison between Viscoelastic Mechanical and Chemical Kinetic Aging Model of Asphalt Concrete. IOP Conference Series: Materials Science and Engineering, 982, 1, 012065. (2020).

Susanto, H.A., Yang, S.H., Kao, C.T., and Huang, C.W. Effect of Viscoelastic Material in Hot Mix Asphalt Rutting Performance Correlation Using Different Wheel-Tracking Test. International Journal of Pavement Research and Technology, 1-13. (2020).

Sumiati, Mahmuda, dan Syapawi, A. Pekerasan Aspal Beton (AC-BC) Limbah Plastik HDPE yang Tahan Terhadap Cuaca Ekstrem. Construction and Material Journal. (2019). Vol.1 No.1.

Susanto, I., dan Suaryana, N. Evaluasi Kinerja Campuran Beraspal Lapis Aus (AC-WC) dengan Bahan Tambah Limbah Plastik Kresek. Jurnal Aplikasi Teknik Sipil. (2019). Volume 17, Nomor 2.

Abdo, A.M.A. Investigation The Effects of Adding Waste Plastic on Asphalt Mixes Performance. ARPN Journal of Engineering and Applied Sciences, Vol.12, No. 15. (2017).

Susanto, H.A., Merdiana, K., dan Indriyati, E.W. Pengaruh Penambahan Limbah Plastik Polypropylene (PP) Terhadap Ketahanan Ravelling Campuran Asphalt Concrete Wearing Course. Jurnal Jalan-Jembatan 38 No. 2 (I-IX), 85-94. (2021). Direktorat Bina Teknik Jalan dan Jembatan, Direktorat Jenderal Bina Marga, Kementerian Pekerjaan Umum dan Perumahan Rakyat.

Fitri, S., Saleh, S.M., dan Isya, M. Pengaruh Penambahan Limbah Plastik Kresek Sebagai Substitusi Aspal Pen 60/70 Terhadap Karakteristik Campuran Laston AC-BC. Jurnal Teknik Sipil. (2018). ISSN 2088-9321, pp.737-748.

Yamali, F.R. Pengaruh Penambahan Limbah Karet Ban Luar Pada Lapis Tipis Aspal Pasir (Latasir) Terhadap Karakteristik Marshall. Jurnal Civronlit Universitas Batanghari. (2017). Vo.2, No.2.

Indriyati, E.W., dan Susanto, H.A. Kajian Sifat-Sifat Reologi Aspal dengan Penambahan Limbah Ban Bekas. Dinamika Rekayasa. (2015). Vol.1, No.1.

Hariyadi, H., Pratama, Y., Sigit, Fadhilah, L., Maryunani, W.P., dan Sudarno. Pengaruh Ukuran Crum Rubber Mesh #80 dan Mesh #120 pada Penambahan Campuran Laston untuk Perkerasan Jalan. Reviews in Civil Engineering. (2018), V.02, N.2, P.82-85.

Refbacks

  • There are currently no refbacks.